Windsor SPIRIT DUAL SPD-J Manual page 7

15.) Ventilate the room when cleaning has
been completed. Keep all traffic off the
floor until it is thoroughly dry.
16.) When done cleaning for the day bring
the machine to a utility sink and floor
drain. Perform the daily/regular
maintenance. Set the recovery tank
aside so solution tank will dry.
CAUTION:
When not using the machine put the
brush in the storage position.
(see daily maintenance on page 8)
Leaving the brush on the floor for
long periods of time may ruin it.
To Use an Accessory Tool:
1.) Turn the machine completely off and
unplug it from electrical outlet.
2.) Connect the solution hose to the brass
fitting on lower left side of machine.
3.) Connect the vac hose to the left side of
the dome (side with white hose cuff).
4.) Fill the solution tank.
5.) Plug the machine in and turn on only
the vac/pump switch. Also place the
water control switch in the " HIGH"
position.
CAUTION:
Using accessory tool with brush
switch on may damage floor.
6.) Turn off the machine and unplug it
from electrical outlet before
disconnecting accessory tool.
Approved Accessory Tools:
Standard Floor Wands
(SFW, SW, or SW-PRO)
Deluxe Hand Tool (DHT)
Upholstery Hand Tool (UPH3)
Floor Surface Inspection:
Determine precisely what areas you are going to
clean. Note the problem areas in the carpet or
hard floor. Look for loose carpet, heavily dam-
aged areas, discolored stains or grease spots
that will require prespotting. Note the carpet or
hard floor type. Check the availability of hot wa-
ter, drains, and suitable electrical outlets. If the
carpet is loose or worn or there is hard floor sur-
face flaking, have it repaired before attempting
to clean it.
Plan Cleaning Route:
Work from the most remote area towards the
exit. Try not to travel over the cleaned areas
when getting fresh water or dumping old. Furni-
ture should be moved away from the walls be-
fore cleaning. If furniture is moved back in place
before floor is completely dry, place plastic or foil
protectors under the legs to prevent possible
staining. When possible use a Windblower
drying.
General Cleaning Information:
Vacuum carpet or sweep hard floor first!
ways take the time to thoroughly vacuum carpet
or sweep floor before using the extractor.
On heavily soiled floors, or on areas of high
foot traffic, it may be necessary to use a pres-
pray or traffic lane cleaner applied with a sepa-
rate sprayer. Do not add presprays to the ma-
chine' s solution tank. If a spotter is used, follow
the manufacturer' s instructions exactly as
printed on the label. Spotter left on the floor may
bleach or brown it permanently.
Shag or deep pile carpets may require several
passes from different directions, but the opera-
tor must be careful not to over saturate the car-
pet. Make several passes without spray to ex-
tract as much moisture as possible.
Rinse carpet after cleaning so that sticky soap
build-up will not cause carpet to quickly become
soiled again. Go back over carpet using only
clean warm water in solution tank.
Al-
7