Brother MFC-9125CN Quick Setup Manual page 35

Wireless Network
h
The wizard will search for wireless networks
available from your machine. Choose the SSID
that you wrote down for your network in
step 18-a on page 28, and then click Next.
Note
• If the list is blank, check that the access point
has power and is broadcasting the SSID, and
then see if the machine and the access point
are within range for wireless communication.
Then, click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Advanced button. Follow the on-screen
instructions for entering the Name (SSID), and
then click Next.
i
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to k.
j
Enter the Network Key you wrote down in
step 18-a on page 28 and then enter the key
again in Confirm Network Key, then click Next.
k
Click Next. The settings will be sent to your
machine.
Note
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry.
l
Disconnect the USB cable between the
computer and the machine.
m
Click Next to continue to install MFL-Pro Suite.
Wireless setup is now complete. A four
level indicator at the right of your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step 21-d on page 42.
Now go to
page 42
Macintosh
35