Technics SH-AC500D Operating Instructions Manual page 4

i
etj
[]
Accessories
Please check and identify
_.,_ :_ the supplied accessories
[] [] AC power supply cord (SJA175-A) ................................ 1 pc.
[] [] Stereo connection cables (RJL2P004B08) ................ 2 pcs
[] [] Monaural connection cables (RJL1 P021B08) ............... 2 pcs
[] [] Optical4iber cable (SJP2281) .............................. I pc
[] [] Batteries ........................................................ 2 pcs
[] [] Remote control transmitter (EUR645403) ....................... 1 pc
Use numbers indicated in parentheses when asking for replacement
parts
(Only for U.S.A )
To order accessories contact 1-800-332-5368 or web site
(http:/hNww.panasonic.com).
Insert the batteries in
the correct polarities
(®, e).
[] ........................ ................
Avoid any obstacles
30 30
About 7 meters (23 feet) in Transmission
front of the signal sensor (The window
actual range will depend on the
angle at which the remote
control is used)
• Thoroughly clean the battery compartment before inserting new
batteries
• Do not mix o_d and new batteries, or batteries of different types
(carbon and alkaline, etc.)
• If you will not use the remote control for a long period of time,
remove the batteries and store them in a cool, dark place
• DO not use rechargeable type batteries•
• Do not attempt to recharge alkaline or carbon batteries•
• Always remove old, weak or worn-out batteries promptly and
dispose of them properly.
• Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
• If leaking electrolyte comes into contact with skin or clothes, flush
with water immediately.
When you need to replace these batteries
Use two R6/LR6, AA, UM-3 batteries•
Be sure the transmission window and the signal sensor are free
from dust. Excessive dust might effect performance.
Operation may not be correct if direct sunlight or other strong light
source strikes the signal sensor of this unit. If there _s a problem,
place the unit away from the light source•