Panasonic Omnivision VHS PV-C2061 Operating Instructions Manual page 43

;heck the following points once again if you are having trouble with your unit.
No power.. • Completely insert Power Plug into an AC outlet.
• Set POWER button to ON.
No picture or sound.. • Make sure your antenna system (TV or CABLE), is correctly set. (P 8-11)
• Completely insert Power Plug into an AC outlet.
• Set POWER button to ON.
Poor picture with normal sound. • Adjust BRIGHTNESS, SHARPNESS, and PICTURE controls in the
SET UP TV menu. (P. 21)
Poor sound with normal picture.. • Adjust VOLUME control. (P. 16)
Poor TV reception... • Adjust SHARPNESS and PICTURE controls in the SET UP TV menu. (P 21)
No color or poor color. • Adjust TINT and COLOR controls in the SET UP "IV menu. (P. 21)
Ghost(multiple) images... • Install a directional antenna.
TV programs cannot be watched... • Make sure the selected channel is in unit's memory. (P. 12, 13)
Channel cannot be selected... • Only the channel being recorded can be viewed on this unit.
TV program cannot be recorded... • Make sure your antenna system (TV or CABLE), is correctly set. (P. 8-11)
• Make sure cassette record tab is intact. (P.4)
Timer recording cannot be • Check that clock is set to current time and date.
_rformed.. • Make sure DSS/CABLE box (if used) is left on and tuned to channel to
be recorded
• Set recording Start/Stop times correctly. (P. 24-25)
• Timer recording may not be performed or continued ifa power
interruption of more than 1 minute occurs before or during a Timer
recording even after power is restored.
No playback picture, or the playback • Adjust TRACKING control in either direction (P 42)
picture is noisy or contains s_eaks_ • Try Head Cleaning. (P. 42)
VCR cannot be controlled... • Make sure VCR LOCK is set to off. (P. 33)
• Make sure unit is not in a Timer Record operation.
Unit cannot be controlled... • Aim remote at remote sensor on unit (P. 7) so that signal is
unobstructed
• Inspect the remote batteries. (P. 4)
• Make sure VCR LOCK is set to off. (P 33)
• Exposing unit remote sensor to direct fluorescent or outdoor light may
cause signal interference.
ACTION, PROG/VCR+ and FM/ • Press COMBO button for COMBO mode. (P 28)
TV buttons cannot be selected .... Check remote batteries.
Video cassette cannot be • Insert the cassette window side up; record tab facing you.
inserted...
Video cassette cannot be • Completely insert Power Plug into an AC outlet.
removed...
Tape cannot be ejected or • Try ejecting or inserting the tape again after turning POWER off, then
inserted., back on
Video cassette ejects when a • Make sure cassette record tab is intact. (P 4)
recording is started, or the power
is turned off for timer recording...
In Stop mode, the VCR motor • To enable Quick Play mechanism, the VCR cylinder will rotate for
CYLINDER) continues to rotate.., about 3 minutes. This reduces response time from Stop to Play mode
and from Play to Rewind Search mode.
VCR cannot be controlled .... Make sure VCR LOCK is set to off. (P. 33)
If rou cannot resolve the problem, please call the Customer Satisfaction Center for
)roduct assistance at 201-348-9090.
To locate an authorized servicenter call toll free 1-800-211-PANA(7262)
or send e-mail to : consumerproducts@panasonic.com.
43