Panasonic Omnivision VHS PV-C2061 Operating Instructions Manual page 25

C_a_ncela Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
o cancel the -rimer Recording.
Any future daily or weekly recordings
willbe performedas programmed.
I
2
Repeat steps 1 and 2 on page 24.
P_ ,, _.o_,_. s Po 1
2 8 lO:0Oa12:00p125 SP|
3 10 8:00p 9:00p 10 SP|
4 SLI 9:OOplO:0Og L LP_
/
CANCEL ; ADD/DLT |
SELECT 1-8:A •
J
ENTER :b
END : PROG/ACTION
Press AY to select
the desired program.
EJECT LIGHT
SELECT/
SET
,=:CH UP
--'_':C H DOWN
I' :VOL UP
:VOLDOWN
-PROGNCR+
--ADDIDLT
3
To Replace program...
STOP 1) Press • to display.
2) Press JI_V to select
and press • or •
to set new program
SELECT:A •
SET :_ ,- contents.
E.D :P.O./ACT,OR 3) Press PROGNCR+
(or ACTION).
To Clear program...
P DT START STOP CH SPO
2 8 10:00p12:00_125 S_
3 10 8:00p 9:(X)p 10 SP
4 SU 9:00plO:0Op L LP
SELECT 1-8:A •
ENTER :_
END :PROG/ACTION
Press ADD/DLT.
Press PROG/VCR+ twice (or ACTION)
to exit this mode.
0
• 2 minutes before Timer recording is performed,
"PLEASE PREPARE FOR TIMER REC" appears
and/or the PROG TIMER Indicator flashes.
Be sure a cassette with record tab is loaded and the
unit is in Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up
during a normal recording or One Touch Recording
(page 14), the Timer Recording will not be performed.
• If there is a power interruption of more than one
minute, the recording may not be performed or
continued.
• If "INCOMPLETE" appears after all items have been
set, check all entries and make necessary
corrections.
25