Panasonic Omnivision VHS PV-C2061 Operating Instructions Manual page 32

Set to see a recording over and over.
Press ACTION*
to display MAIN MENU.
2
MAIN MENU
CH CLOCK EX I T
SELECT:A • • I-
SET :ACTION
1) Press AV, I_
to select "VCR."
2) Press ACTION
to display SET
UP VCR screen.
3
SET UP VCR
TIMER PROGRAMMING
TIME STAMP : ON
REMOTE WARN I NG : ON
SELECT:A •
SET :_
END :ACTION
1) Press AY to
select "REPEAT
PLAY."
2) Press I_ to set
REPEAT PLAY
"ON" or "OFF."
Press ACTION twice
to end setup.
By pressing the CM/ZERO button in Playback
mode you can skip over 1 to 3 minutes of
recorded tape in just a few seconds.
Press CM/ZERO repeatedly to
select skip time in Play mode.
• No indication appears.
OFF
!
1st Press ---,-1 min Skip
2nd Press----_2 min Skip
l
3rd Press---,-3 rain Skip
• Playback repeats when tape end is reached
or unrecorded portion over 30 seconds is
detected.
• During playback, you may also press
PLAY/REPEAT repeatedly on the unit to
select REPEAT "ON" or "OFF."
To quickly retum to a specific tape counter location.
Press DISPLAY during playback
to display the Counter.
2
o:00:00
BEGIN END
Press COUNTER
RESET at the
desired position to
reset to "0:00:00."
Continue playback, rewind, or
fast forward.
Press STOP.
1:23:45
5
BEGIN ENO
Press CM/ZERO
in stop mode to
start ZERO
SEARCH.
ACTION-
RESET
m F_JE_t LIGHT
O@®
c_ cD c_!
SELECT/
--SET
,_:CH UP
_:CH DOWN
1':VOL UP
4 :VOL DOWN
-DISPLAY
• : Present position mark
V : Zero position mark
• Unit goes into FF or REW mode and • If a blank portion exists on the tape, and
stops at the last point the Counter was depending on the position of the V mark,
set to 0:00:00. the V mark display may be out of position.