Installation Of; Unpacking; Unpacking Steps; Repacking Steps - Epson MX-82 Operation Manual

INSTALLATION OF MX-82

1. Unpacking

Before removing the MX-82 from the carton, check the box for evidence of shipping
damage or mishandling. If such evidence is present, notify the carrier immediately.

1.1 Unpacking steps

Unpacking steps are as follows:
STEP 1. Open the carton.
2. Remove accessories.
3. Remove the MX-82 holding its underside and lifting it straight up with the
packing materials attached.
4. Place the Printer with the packing material on a table or any other conven-
ient flat surface.
5. Take off the packing materials carefully.
6. Remove the vinyl cover.

1.2 Repacking steps

Repacking can be carried out by following the above steps in the reverse order. (Re-
packing: Shipment for repair, storage, etc.)
NOTE: It is recommended that all original packing materials be saved for reuse in
case the MX-82 requires reshipment in the future.
2. Counting Parts
The MX-82 and standard accessories are as shown in Fig.2. Upon unpacking, if you
notice any listed contents missing or evident damage, contact the store where you
purchased the MX-82 as soon as possible.
- 3 -