Column Layout On Fanfold Paper; Top Of Form Position Setting; Fig. 35 Top Of Form Position Setting - Epson MX-82 Operation Manual

7.1.3 Column layout on fanfold paper

When fanfold paper of from 4" to 10" in width is supplied with the MX-82 F/T, the
graduations on the scale can be used as the indexes of print column positions (I to
96). Alignment of the print start position on fanfold paper with the 1st column posi-
tion at the extreme left of the scale will facilitate column layout. Accordingly, center
the paper by adjusting it to these indexes of the scale.

7.1.4 Top of form position setting

The term "Top of Form position" is defined as the position in which the first print line
lies on the form, and this position is determined when the power switch is turned
on. Namely, adjust the paper position by the manual paper feed knob so that the re-
quired line position (i.e., the point at which the first line of the form is desired to be
printed) is at the print head level. If, at this point, power is applied to the Printer, this
line position automatically becomes the Top of Form position.
When printing forms, the matchmarks located on both the sprockets facilitate the
setting of the Top of Form position on the fanfold paper. To set the Top of Form po-
sition, first enter (or preprint) a mark at a position on the edge of the paper 77 mm
above the first print line position of the paper, then align this mark with the match-
marks on the sprockets by turning the manual paper feed knob. At this point, turn
the Power Switch on and the Printer will recognize this position as the Top of Form
position. Now, the printing can be started from the Top of Form position. (See Fig.
35)
In case of feeding one page of fanfold paper by operating the MX-82 F/T by the in-
put of FF code, the abovementioned adjustment is effective.

Fig. 35 Top of Form Position Setting

- 2 0 -