Table of Contents
Advertisement
Pull the paper bail forward. Open both tractor covers and center the paper guide
roller between them (Figure l-10).
Paper Holding Covers
Feed the incoming paper
the slot and right on around to the tractors. Move the tractors as necessary to
match the hold spacing in the paper. The tractor position lock levers are shown
in Figure l-10.
Position the paper holes on top of the tractor teeth and close the tractor covers.
Adjust one or both tractors so the paper is centered as you wish it, and is held
firmly in place. Push the bail back up against the paper.
Roll the paper forward with the roller knob.
The printer moves paper
the roller back manually, the power should be OFF; it helps to pull lightly on the
paper.
Pull the bail back out of the way and set the paper so the top of a new sheet is
positioned right at the scribe mark on the metal platen (Figure l-11). Push the
bail back up against the paper.
Tractor Position Lock Lever
Paper Holding Cover
Figure 1-10
the plastic tube but
above
only, and never looks back. If
forward
Paper guide roller
Tractor Position Lock Levers
the wire frame, into
below
we must
The Starting Line
turn
9
Advertisement
Table of Contents
