Table of Contents
Advertisement
Opening the Case
To locate the wiring terminals, we have to open the case. The lid should still be
off. Remove the roller knob by pulling straight out, with firm but steady
pressure (Figure l-5).
Turn the printer upside down on a soft surface. With a Phillips-head screwdriv-
er, completely loosen (but don't remove) all 4 corner screws as shown in Figure
l-6. Place tape over the 4 holes so the screws won't fall out when we tip the
printer right-side up again.
Now tip the printer right-side up again.
wiggle the top cover loose.
Gently
completely remove the cover - only open it enough to gain access to the main
wiring board.
Lift the cover up, mostly from the left side, and slide it
free it from the roller shaft.
side. With just a bit of class we can maneuver the cover so it stands solidly in
place, as a sentinel guarding the goodies.
Figure 1-5
Figure 1-6
Wires are booked to it!
not to pull the wires on the right-hand
Be careful
We are
going to
not
to the right to
gently
The Starting Line
5
Advertisement
Table of Contents
