Table of Contents
Advertisement
Installing Backsplash Panels
Flat backsplash panel
Material gauge – Stainless
Wall
Wall
Panels up to 47 inches (119.4 cm) wide ship in one
piece. Over 47 inches (119.4 cm) in multiple pieces.
Insulated backsplash panel
Material gauge – Stainless
Insulation – 1 inch (25.4 mm)
Wall
Wall
Length
Length
Panels up to 45 inches (114.3 cm) wide ship in one
piece. Over 45 inches (114.3 cm) in multiple pieces.
14
Model GGH2O
Heigth
Heigth
Length
Length
NOTE
1 inch (25.4 mm)
1 inch (25.4 mm)
Height
Height
NOTE
1. After the hood is hung in position, slide the flat
flange of the backsplash panel behind the back of
the hood.
Note: If the backsplash panel length is greater
than 45 in. (114.3 cm), it will be shipped in multiple
pieces.
2. After the backsplash panel has been positioned,
drill holes in the panel and fasten to the wall.
(Fasteners provided by others).
Note: The holes should be spaced to adequately
secure the panel to the wall.
3. Caulk the joints between the hood and the
backsplash panel with NSF Approved silicone
caulk (GE SCS1000, or its equivalent). The caulk is
not provided.
4. Caulk the joint between the backsplash panels
when multiple panels are required, with NSF
Approved silicone caulk (GE SCS1000, or its
equivalent). The caulk is not provided.
Hood End Panel
Holes should be spaced
to adequately secure the
panel to the wall studs.
(Hole spacing and fasteners
provided by others).
Hood Front Panel
Slide flange
behind back
of the hood.
Backsplash Panel
Section view of
backsplash panel
overlap
®
Advertisement
Table of Contents
