Clear Cmos (Jp3); Usb Front Panel Header (J2) - TYAN Thunder n3600T User Manual

2.04 – SAS Disable Jumper (JP1)
For external disable SAS controller
(Default)
2.05 – OPMA card supporting select header (JP2)
(Default)
2.06 – Clear CMOS (JP3)
Normal
(Default)
Clear
2.07 – USB Front Panel Header (J2)
Installed: Disable
Not installed: Enable (Default)
When using other OPMA card, remove jumper
When using TYAN OPMA card, install jumper
(default)
Use this jumper when you have forgotten your
system/setup password or need to clear the system
BIOS settings.
How to clear the CMOS data
Power off system and disconnect the power
-
supply from the AC source
Use jumper cap to close pin_2 and 3 for several
-
seconds to clear the CMOS
Replace the jumper cap to close pin_1 and
-
pin_2 Reconnect the power supply to the AC
source and power on the system
VCC
1
DATA-
3
DATA+
5
GND
7
KEY
9
14
http://www.TYAN.com
VCC
2
DATA-
4
DATA+
6
GND
8
NA
10