Table of Contents
Advertisement
If the AV device is switched
on and correctly
connected,
and the LCD TV/Monitor
is set to AV (or S-VIDEO
if using S-Video
cable instead
of RGB) then the AV feed will start playing automatically.
When in AV (or S-VIDEO)
mode, press the MENU button on the remote control to show the main menu as shown below:
D
VIDEO
ADVANCE
OSD
SETTING
RESET
INPUT
SOURCE
NO
SYNC
The operation
and functions
of the AV (and S-VIDEO)
menu are identical to those in TV mode as described
above.
To use your unit as a computer
monitor:
1.
Press the INPUT button on the remote control until "PC" appears
in the top right of the screen.
2.
If you do not have a computer
connected
a blank screen will appear with a box containing
the words "NO SYNC".
If this
is the case ensure
that your computer
is powered on and is plugged
correctly
into the sockets on your LCD TV/Monitor
with the serial cable.
3.
To receive
sound from your computer
through the speakers
in your LCD TV/Monitor,
connect
the single pin audio cable
(supplied)
to the AUDIO
IN socket
on the rear panel of the unit and the other end to the audio out socket
on your
computer.
Note: if you cannot receive
the video signal on the monitor
or it sometimes
drops in and out it is because
of hardware
or software
incompatibility
between
your computer
and the LCD TV/Monitor.
Typically
this would only occur with older computers
with an
older model display card or old operating
system.
In this case try the following:
1.
Adjust display settings
on your computer
- with your old monitor connected
in place of the LCD TV/Monitor,
right-click
on
the Desktop
and select Properties.
Select the Settings
tab.
Adjust the screen resolution
to "640 x 480".
Then click
Advanced
and go to the Monitor
tab, then Monitor
Settings.
Adjust the Screen
Refresh
Rate to "60 Hertz".
Apply
21
- Quick Links:
- Ac Power Supply Cord
Hide quick links:
Advertisement
Table of Contents
