Television; Scanning And Editing Channels - ProScan 19LA20Q Instruction Manual

Before you can receive television reception you must scan the channels so that they are set into the memory of your new LCD
TV/Monitor.
1.
Press the power button either on the unit or remote control. A blank screen will appear with the following text box
showing:
TV O
NO SYNC
2.
3.
4.
5.
6.
7.
8.
Note: If your unit does not show this screen it may not be set to the TV mode. In this case press the INPUT button
on the remote control repeatedly until "TV" appears in the top right corner of the screen.
Press the MENU button on the remote control to display the TV mode MAIN MENU.
Press the DOWN arrow key one time to highlight TV SETTING then press the MENU button to select.
Press the DOWN arrow six times (or alternatively the UP arrow once) to highlight AUTO SEARCH and press MENU
to select.
Highlight YES using the RIGHT arrow key and press MENU to start auto search.
Wait while the unit scans for and sets the television channels into its memory.
Press EXIT twice to exit out of the menu system.
To skip unwanted TV channels, set the "SKIP THIS" to "YES" under TV setting. Refer to page 19, "REMOVING A
CHANNEL" for more details.
O
TV MODE A_R
SKIP THIS ON
AUTO FINE ON
FINE TUNE
2S0 HHZ
AUTO SEARCH
SWAP
]4