Msb Control - Epson EX-1000 User Manual

ESC EM
Format:
ASCII code:
Decimal:
Hexadecimal:
Comments:
The following values can be used for n:
4: Mode is turned ON.
0: Mode is turned OFF
The command should not be used unless the automatic sheet feeder
is installed. It is ignored if any value other than "0" or "4" is used for
n. The command overrides the setting of DIP switch 2-2.
The variables are the characrers "0" (48 decimal or 30 hex) and "4"
(52 decimal or 34 hex). Do not use 1 decimal, 01 hex, 4 decimal, or
04 hex.

MSB control

Note: MSB is the Most Significant Bit. MSB control (ESC = , ESC >,
and ESC #) does not work for graphics or user-defined
characters.
Comments:
Sets the MSB of all incoming data to 0. Some computers always send
data with the MSB set to 1, which means that italics or character
graphics will always be printed. ESC = can overcome this problem.
Command Summary
Turn Automatic Sheet Feed Mode On/Off
ESC EM
n
27 25
n
1B 19
n
A-11