Input Source Selection (Component, Rgb Scart 21-Pin); Direct Operation - Sanyo PLC-XU105 Owner's Manual

Input Source Selection (Component, RGB Scart 21-pin)

Direct Operation

Choose Computer 2 by pressing the INPUT button on the
top control or press the COMPUTER button on the remote
control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
pointer to the Input Menu icon.
2
Use the Point
▲▼
pointer to Computer 2 and then press the SELECT
button.
3
After the Source Select Menu appeared for Computer
2, move the pointer to Component or RGB(Scart) and
then press the SELECT button.
When the input source is coming from video
Component
equipment connected to the COMPUTER
IN 2/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the COMPUTER
IN 2/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
 Note:
• When the Input Search function is set to "On1" or "On2",
the input signal will be searched automatically (p.47).
buttons to move the red frame
◄►
buttons to move the red arrow
Top Control
INPUT button
REMOTE CONTROL
COMPUTER button
Input Menu icon
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
Computer
2
Source Select Menu
Move the pointer to Component
or RGB(Scart) and press the
SELECT button.
Video Input
Computer 1
Computer 2
Video
Computer 1
Computer 2
37