Table of Contents
Advertisement
After you finish connecting
the TV, you need to run the Initial Setup
feature, which automatically
creates a list of available
analog and
digital channels
and lets you correct tilt and vertical correction
settings. The Initial Setup screens appear when you turn on your TV
for the first time after hooking
it up.
Using
Initial
Setup
_For
moredetails on using
Tilt CorrectionandVertical
Correction,seepages45-46.
N
To exit the Tilt Correction
and Vertical Correction screens,
pressthe M_/;
button.
/% _'_ _'_ts, 5d;p
'l
Press H;W/i: to turn on the TV.
The Initial Setup screen appears.
Using the remote control, move the highlight
to the desired
language,
then press @
to select that language.
The Tilt
Correction
screen appears.
Press *, ,÷, t o correct any tilt of the picture. You can choose a
correction
between
+7 and -7. When finished,
press @.
The Vertical Correction
screen appears.
Press e #_to make a
vertical correction
to the picture. You can choose a correction
between
+5 and -5. When finished, press @.
_.
The next screen instructs
you to connect your cable/antenna.
Check that you've connected
your signal source correctly.
To start Auto Program,
highlight
?;,; and then press @.
Auto Program
automatically
creates a list of receivable
analog
and digital channels. Auto Program may take 50 minutes
or more
to complete.
A progress
bar is displayed
while the channel
list is
being created.
When Auto Program
is finished,
the lowest numbered
channel is
displayed.
Use the Auto Program
feature as described
on page 40.
Use the Digital Channel
feature as described
on page 40.
kz
IV _ofac/_:;r;: s ;, I : _ '_(_5
1
Press
?OW{R to turn ori the TV.
Hold down RiStTon the remote control.
Press/V ! (%',!!_on the TV. (The TV will turn itself off, then back
on).
_
Release Hq!i
Advertisement
Table of Contents
