Setting Up The Channel List; Using Auto Program; Control - Sony WEGA KV-30XBR910 Operating Instructions Manual

Setting Up the Channel List
After you finish connecting your TV, you need to run Auto Setup to
set up your channels. The Auto Program screens appear when you
turn on your TV for the first time after hooking it up.
Using Auto
Program
_I] Toexitthe Tilt Correction
and VerticalCorrectionscreens,
pressthe MENUbutton.
L'! Formoredetailson using
Auto Program,seepage84.
Formoredetailson usingTilt
CorrectionandVertical
Correction,seepages89-90.
TorunAutoProgram thefirst timeyouturn onyourTV
1
Press POWER t o turn on the TV.
The Initial Setup screen appears.
2 Using the joystick on the remote control, move the highlight to
the desired language, then press O to select that language.
The next screen instructs you to connect your cable/antenna.
Check that you've connected your signal source as described on
pages 16 to 22.
To start Auto Program, move the joystick to highlight Yesand then
press O.
Auto Program automatically creates a list of receivable channels.
When Auto Program is finished, the Tilt Correction screen
appears.
4
Move the joystick * * to correct any tilt of the picture. You can
choose a correction between +7 and -7.
When finished, press _. The Vertical Correction screen appears.
5 Move the joystick • • to make a vertical correction to the picture.
You can choose a correction between +5 and -5. When finished,
press O-
The lowest numbered channel is displayed.
Toreset the TV to factory settings
1
Press POWERto turn on the TV.
2 Hold down RESET on the remote control.
Press TV POWERon the TV. (The TV will turn itself off, then back
on.)
4 Release RESET.
41