General - Sony SXRD KDS-60A2020 Operating Instructions Manual

Other Information
Some digital cable channels are KA Certain cable companies have limitations on the broadcast of digital cable
not being displayed channels. Check with your cable company I_r more in%rmation.
KA The digital cable channel may be set to Hidden in the Channel setting (see page
41).
General
How to reset the TV to Ii_ctory KA Turn on the TV. While holding down the tl, button on the remote control, press the
settings POWER button on the TV. Release the POWER button then release the tl, button.
The TV will turn itself off, then back on again with Initial
Setup.
WARNING: This operation will clear all of your cnstomized settings including
Parental Lock
setting.
How to restore Picture settings KA Select Reset setting option while in the Picture setting (see page 34).
to t:actory settings
How to restore Sound settings KA Select Reset setting option while in the Sound setting (see page 37).
to factory settings
Cannot cycle through the other KA Be sure the Label Video
Inputs
option is not set to Skip (see page 45).
video equipment connected to
the TV
Cannot operate the setting KA If a setting option appears in gray, this indicates that the setting option is not
available.
Lost password KA On the password screen, enter the following master password: 4357. The master
password clears your previous password; it cannot be used to temporarily unblock
chtmnels.
TIMER LgDon froni panel Whei_iit ii_ciic;;ies i hai ihe iinaer issei isee page 46i1Whe;_ iiaeiiiaaer{s sei; ihis ......
lit LED will remain lit even when the TV is turned off.
POWER LED blinks in red KA If the LED blinks three times, the lamp door or the lamp might not be securely
attached (see page 51 ). The LED blinks two times if there is an abnormal rise in
.......................................................... temperuture !nside the ...............................................
LAMP LED blinks in red KA Replace the lamp (see page 51).
The replacement lamp does not KA The lamp door or the lamp might not be securely attached. Repeat the steps on
light up page 51 to ensure that they are both installed securely.
Digital cable box does not work KA If you are connecting a VCR and digital cable box using a splitter, as described on
page 17, you must use a special bi-directional splitter that is designed to work
with your digital cable box. Contact your cable provider for details.
TV cabinet creaks KA When the TV is in use, there is a natural rise in temperature, causing the cabinet to
expand or contract and may be accompanied by a slight creaking noise. This is not
a malfunction.
A slight creaking noise occurs 1_ Advanced Iris applies a mechanical iris system. When Advanced Iris is set, a
from the bottom part of the TV natural creaking noise occurs due to the basic structure of the optical unit. The
......................... creak!ng sound is an
!nherent
nature 0f th!s systeln an d is not a defect. .........
The cooling fan is loud KA If the TV is used at high altitudes and
Cooling
Mode is set to High, the cooling
fan runs faster and its sound becomes louder. If the TV is not used at high
altitudes, set
Cooling
Mode to Normal (see page 47).
58