Troubleshooting - Sony SA-IF70 Operating Instructions Manual

Setting up the speaker system
Place the L - speaker to the left and the R - speaker to the right.
Place the wireless speakers facin.__each other about 1 m (2 to 3 feet)
above your listening position ([._).
The approximate effective area of the infrared ray emitted from the
transmitter is l0 m (30 feet) (['_l). Adjust the position, direction and angle of
the transmitter so the wireless speakers (STANDBY (red) indicator and
infrared receptor) are within the effective area.
You can place the transmitter on top of the TV, an other component ([=-I).
or hang it on a wall (r_).
Using the speaker system
Set the amplifier's POWER switch to ON.
The power for the transmitter is supplied by the amplifier. When you turn
on the amplifier's power, the transmitter starts emitting infrared rays and
the infrared receptors on the speakers (r_ll) receive the signals. When the
speakers receive signals, the infrared receptor lights up green. If the
infrared receptor lights up red, the signal is not reaching the receptor.
Adjust an angle of the transmitter (V_l).
Notes
• The infrared ray will not penetrate walls or opaque glass.
Therefore, the transmitter must be placed "in sight" of the wireless
speakers.
• Placing the transmitter too far away from the wireless speakers
may cause noise.
• Do not block the path between the wireless speakers and the transmitter.
Otherwise, the speakers will be noisy and then enter stand by mode.
• When you are using other appliances that emit infrared rays at the same
time, may be happen of the jamming, do not use at the same time,
• Use the transmitter only, for keep off the jamming.
• If the sound from the speakers is very soR or not clear, turn the wireless
speakers towards the transmitter.
• When you are using the speaker system for long time, the surface of the
transmitter getting hot but no damage for the unit.
• If you experience noise from the wireless speaker while the transmitter is
disconnected, turn off the power of the input adaptor or amplifier before
disconnecting the plug.
Troubleshooting
No sound or only a very low sound level is heard from the
speakers,
• Make sure the transmitter is securely connected to the amplifier.
• The surround sound is turned off.
• Adjust the volume of the Wireless rear speakers (on the amplifier).
• Check the sound image balance with the TEST TONE feature (on the
amplifier},
• The infrared transmitter is too far from, or not aimed at the Wireless
speaker.
• Remove any obstructions between the transmitter and the Wireless
speakers.
5