Table of Contents
Advertisement
I / .
The VTeqh VT 1911 is capable of
memory
$\sling.
You can dial by
pressing t& memory location in which
the numb$$ was stored.
lar memory location (e.g.
CLWDEL Key Function
The CLEAR and DELETE functions
can be accessed separately depending
on how long the key is held down. For
example, to clear the last di it entered
on the display, press t h e f - 0
'
key for less than 1 second. Press and
hold the
@ L R / D E L )
key for more than
1 second to completely clear the LCD.
The handset LCD will show the ringer
type selected:
Enter the memory location (01 ..20)
you wish to store the number in. As
soon as the second memory
location digit is entered, the unit will
emit a happy tone (a short series
of beeps) to confirm successful
programming and exit program
Press
or
@
to exit.
Turning Off The Ringer
To turn off the ringer do the followin!:
dial tone.
2. Press
(MEM).
You will be
The delete function is also used to
delete CID and speed dial memories,
see DELETING STORED NUMBERS
o n page 23, and
DELETING
NUMBERS on page 28.
prompt,ed to enter a location
number.
3. Enter jhe memory location you
wish to dial. E.g. 15. The number
stored 'at that location will be
shown on the display and will
autom, !ically be dialed.
You c
(I
also review the contents
of the
emory locations when you
are no /connected to a line. When
the p pne is off you can scroll
throug the memory locations by
using
1
he A
( * ) and
V
(
#
)
mode.
TURNING OFF
RINGER
PRESS
PRESS
Q
PRESS
@
PRESS
(i;ohB
THE
STORING SPEED DIAL
NUMBERS
Advanced Dialing
There are two different ways to dial a
DIALYOUR PHONE
NUMBER
PRESS
I
number:
1. Press the
(PHONE)
key and wait
for a dial tone. Then dial the
PRESS LOCATION
(01
....
20)
I
number you want either manually,
using MEMORY (MEM) dialing,
CID dialing or REDIAL.
Checking The Ringer Type
To test the present ringer type, do the
2. Enter the number you wish to dial
on the display first. Then press the
( M E )
key. This will dial the
number which is displayed on the
LCD after 2 seconds.
following:
If programming is unsuccessful the unit
will display:
I
\
CHECKING THE RINGER
TYPE
PRESS
PRESS
@
PRESS
@
AGAIN
PRESS
@
which is shown on the display.
If you do not want to dial the
number shown on the LCD, it
can be changed by:
1
I
Storing speed dial numbers
To program a speed dial location, do
the followlng:
i~
Unsuccessful programming can result
from not correctly completing the
programming sequence. For example,
if after entering a number on the LCD
and entering program mode, the OFF
key were pressed instead of entering
a valid memory location, the
programming incomplete message
would appear. If this message appears,
With ffle phone OFF, enter the
ne number you wish to
Digits Maximum).
Press and hold [CLRIDEL]
until
the display is cleared, then dial
normally.
Press
( a ]
or
(OfF)
to exit.
Wait for the dis lay to clear, then
press
( - 5
and enter the
number you wish to dial.
simply repeat the programming
sequence.
Advertisement
Table of Contents
