Table of Contents
Advertisement
CLRIDEL Key Function
The CLEAR and DELETE functions
can be accessed separately depending
on how long the key is held down. For
example, to clear the last digit entered
on the display, press t h e ( ~ m ~ )
key for less than 1 second. Press and
hold the
e m )
key for more than
1 second to completely clear the LCD.
To end the call, press
or place
the handset back in the base. The
phone will automatically go back to
The handset LCD will show the ringer
tvDe selected:
CID WITH CALL WAITING
If during a normal phone call another
call comes in with CID information,
notification beeps will be heard in the
handset earpiece.
rotarv (dial-~ul sel
I
service.
The new CID information will be
displayed on the LCD for 10 seconds
and will then be stored in memory.
TEMPORARY TONE
DIAL YOUR CALL
NUMBER
PRESS
@
PRESS THE NUMBERS
OR SYMBOLS
PRESS
Press
(m)
or
to exit.
Turning Off The Ringer
To turn off the ringer do the following
-
The delete function is also used to
delete CID and speed dial memories,
see DELETING STORED NUMBERS
on page 24, and
DELETING
NUMBERS on page 29.
Switching calls
To switch over to the new call,
press the phone key, the first call
is put on hold.
To switch back to the first call,
press t h e ( p X ~ ) k e ~ again.
TURNING OFFTHE
RINGER
PRESS
PRESS
@
PRESS
@
PRESS
a
Programming The Ringer
Advanced Dialing
There are two different ways to dial a
he-handset
ringer is capable of four
different types of ringer tones
.
The
following section details how to select
different ringer types and how to turn
off the handset ringer.
SWITCHING CALLS
number:
1. Press the
( m )
key and wait
TO SWITCH OVER TO
THE NEW CALL
PRESS-
for a dial tone.
Then dial the
number you want either manually,
using MEMORY (MEM) dialing,
CID dialing or REDIAL.
Changing Ringer Types
To program, the handset must be
OFF.
Checking The Ringer Type
TO SWITCH BACK TO
THE FIRST CALL
PRESS-
AGAIN
To test the present ringer type, do the
2. Enter the number you wish to dial
on the display first. Then press the
(PHONE)
key. This will dial the
number which is displayed on the
LCD after 2 seconds.
followina:
To select a different ringer type do the
Temporary Tone
If you have a rotary (dial-pulse)
telephone service, (TONEIPULSE
switch is set to PULSE), this feature
allows you to enter special codes and
tones to operate answering machines,
use electronic banking services, calling
cards, or other special services.
CHECKING THE RINGER
TYPE
PRESS
G 3
PRESS
@
PRESS
@
AGAIN
PRESS
NOTE: The phone will dial any number
which is shown on the display,
If you do not want to dial the
number shown on the LCD, it
can be changed by:
Press and hold
(m)
until
the display is cleared, then dial
First, dial the call normally. Then
activate the Temporary Tone feature
by pressing TONE (the
*
key). You can
then press the numbersorsymbols you
need, and your phone will send the
proper signals.
Press
( - 1
or
to exit.
normally.
Wait for the dis lay to clear, then
press
( - 7
and enter the
number you wish to dial.
Press: 1 for ringer type 1
2 for ringer type 2
3 for ringer ;type 3
4 for ringer type 4
0
for
ringer
off
(ringer disabled)
Advertisement
Table of Contents
