Weslo Pursuit 330 User Manual page 6

6, While another person hoUds the Upright (13) in the
position shown, connect the Extension Wire (56) to the
Reed Switch Wire (43), Next, connect the Resistance
CaMe (19) to the Lower Cabb (45) in the following way:
See drawing A, Pull up on the metal bracket on the
Lower Cable (45), and insert the tip of the Resistance
Cable (19) into the wire clip inside the metal bracket
as shown,
See drawing B, FirmUy pull up the Resistance CaMe
(19) and sfide it into the top of the metaUbracket as
shown,
See drawing C, Using pliers, squeeze the prongs on
the upper end of the metal bracket together,
Push the excess Cable (19, 45) and the excess Wire
(43, 56) down into the Frame (1), and insert the Upright
into the Frame, Be carefut to avoid pinching the
CabJes and Wires. Attach the Upright to the Frame
with an M8 x 58mm Button Bolt (6), an M8 Split
Washer (42), and an M8 Nylon Locknut (10),
7, Attach the Seat (12) to the Seat Post (5) with four M8
Split Washers (42) and four M8 Nylon Locknuts (10),
Note: The Split Washers and Nylon Locknuts may be
preattached to the underside of the Seat,
4--13
Be carefuJ to
avoid pinching
the wires and
cables while
inserting the
Upright.
-- 56
B
ii
iS/ 19
Metal_
Bracket
sS
_,' 10
/