Battery Replacement - Weslo Pursuit 330 User Manual

MAINTENANCE AND TROUBLESHOOTmNG
Unspect and tighten aH parts of the exercise cycUe reg-
uUady,RepUace any worn parts immediateUy,
To clean the exercise cycUe, use a damp cloth and a
small amount of mild detergent, Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY
REPLACEMENT
Ufthe consoUe dispUay becomes dim, the batteries
shouUd be repUaced; most consoUe proMems are the
resuUtof Uowbatteries, To repUace the batteries, see
step 4 on page 5 and remove the consoUe from the
handlebar, Next, see step 3 on page 5 and insert
three batteries into the consoUe, Reattach the consoUe
to the handUebar, being carefuU not to pinch the wires,
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted, In order to adjust the
reed switch, the left side shield must be removed,
Using an adjustable wrench, turn the Left Pedal (24)
clockwise and remove it, Next, remove the five M4 x
28mm Screws (41) from the Left Side Shield (17),
Carefully remove the Left Side Shield,
24
\
Next, turn the resistance knob to the lowest setting
With the left side shield removed, locate the Reed
Switch (43), Turn the Crank (21) until the Magnet (38)
is aligned with the Reed Switch, Loosen, but do not
remove, the M4 x 16mm Screw (49), Slide the Reed
Switch slightly closer to or away from the Magnet,
Retighten the Screw, Turn the Crank for a moment,
Repeat until the console displays correct feedback,
When the Reed Switch is correctly adjusted, reattach
the left side shield and the left pedal,
11