Assembly - Weslo CADENCE 340 CS User Manual

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dis-
pose of the packing materials until assembly is completed. In addition to the included allen wrench, assembly
requires a phillips screwdriver, (_=======_ an adjustable wrench __ and scissors _.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Handrail Washer (80)-4
Latch Screw/Rack Screw (14)-14
_,_ _ _ Handrail Bolt (1)-4
Extension Leg Screw (39)-2
Handrail Star
Washer (2)-4
Console Screw (3)-4
1. With the help of a second person, raise the Uprights (38)
to the position shown. During this step and step 2, be
careful not to pull on or damage the Wire Harness (53)
in the right Handrail (4).
Insert one of the Base Legs (44) into the right Upright
(38), with the Base Leg Pad (33) in the indicated position.
Using the included Allen Wrench (81), attach the Base
Leg with a Base Leg Screw (39). Attach the other Base
Leg (not shown) to the left Upright in the same way.
Note: A replacement Base Leg Pad (33) may be included.
If a Base Leg Pad becomes worn and needs to be
replaced, use the replacement Base Leg Pad.
2. Hold a Handrail (4) against the left Upright (38) as
shown. Important: If you are shorter than 5' 8", align
the upper two holes in the Handrail with the holes in
the Upright; if you are 5' 8" or taller, align the lower
two holes. Attach the Handrail with two Handrail Bolts
(1), two Handrail Washers (80), and two Handrail Star
Washers (2) as shown. Do not tighten the Handrail
Bolts yet.
Make sure there is at least 6"-8" of the Wire Harness (53)
coming out of the top of the Handrail (4). Feed the
excess Wire Harness into the right Upright (38), and hold
the right Handrail against the Upright. Make sure that
both Handrails are at the same height. Attach the
Handrail with two Handrail Bolts (1), two Handrail
Washers (60), and two Handrail Star Washers (2). Do
not tighten the Handrail Bolts yet. Be careful not to
pinch the Wire Harness. Remove the tie from the Wire
Harness and the Handrail.
81
33
38
/
53
53