Weslo CADENCE 340 CS User Manual page 6

3. HoldtheConsole Base(87)nearthe rightHandrail (4).
Makea loopwiththeindicated plastic tie andinsert t he
twoWires(53)through theloop.Pulloutonlyenough
Wiretoconnect theWirestothetwoconnectors i nthe
Console Base(87).
Important: Make sure that the
Wires are fully inserted. WARNING: Do not discon-
nect or connect the Wires while the treadmill power
cord is plugged in.
Refer drawing 3a. Set the Console Base (87) on the
Handrails (4). Thread four Console Screws (3) into the
Handrails and the Console Base. After all four Screws
have been started, tighten the Screws until they are
snug; do not overtighten the Screws.
Feed the excess Wire Harness (53) into the upper end
of the right Handrail (4). Pull the plastic tie tight and cut
off the end.
Plastic
Tie
3a
Plastic
Tie
87
4. Attach the Storage Latch (16) to the left Upright (38)
with two Latch Screws (14).
Refer to step 2. Tighten the four Handrail Bolts (1).
16
14
5. Hold a Weight Rack (15) against the right Upright (38) in
the position shown. Loosely thread two Rack Screws
(14) into the bottom holes in the Weight Rack and the
Upright. Next, loosely thread four Rack Screws into the
other four holes. Then, tighten all six Rack Screws.
Set a 3-lb. Weight (not shown) on the bottom hanger on
the Weight Rack (15), a 2-lb. Weight on the middle
hanger, and a l-lb. Weight on the top hanger.
Attach the other Weight Rack and Weights to the left
Upright in the same way (not shown).
15
14
14
Hanger
14
6. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a
mat under the treadmill.