Set Max Lock - Toshiba MK3006GAL Specification

360050398
10.8.31.2 Set Max Set Password
F9h with the content of the Features register equal to 01h.
COMMAND CODE
REGISTER SETTING
DR
CY
HD
SN
SC
FT
LBA
This command is not immediately preceded by a READ NATIVE MAX ADDRESS command. If this command is
immediately preceded by a READ NATIVE MAX ADDRESS command, it shall be interpreted as a SET MAX
ADDRESS command.
This command requests a transfer of a single sector of data from the host. Table 10.8-7 defines the content of
this sector of information. The password is retained by the device until the next power cycle. When the device
accepts this command the device is in Set_Max_Unlocked state.

10.8.31.3 Set Max Lock

F9h with the content of the Features register equal to 02h.
COMMAND CODE
REGISTER SETTING
DR
CY
HD
SN
SC
FT
LBA
This command is not immediately preceded by a READ NATIVE MAX ADDRESS command. If this command is
immediately preceded by a READ NATIVE MAX ADDRESS command, it shall be interpreted as a SET MAX
ADDRESS command.
The SET MAX LOCK command sets the device into Set_Max_Locked state. After this command is completed
any other SET MAX commands except SET MAX UNLOCK and SET MAX FREEZE LOCK are rejected. The
device remains in this state until a power cycle or the acceptance of a SET MAX UNLOCK or SET MAX
FREEZE LOCK command.
1 1 1 1 1 0 0 1
DRIVE No.
01
H
Table 10.8-7 SET MAX SET PASSWORD data content
Word
0
1-16
17-255
1 1 1 1 1 0 0 1
DRIVE No.
02
H
Toshiba Corporation Digital Media Network Company
Page 94 of 157
© 2005, Copyright TOSHIBA Corporation All Rights Reserved
REGISTER
NORMAL COMPLETION
no change
no change
no change
no change
no change
no change
no change
Content
Reserved
Password (32 bytes)
Reserved
REGISTER
NORMAL COMPLETION
no change
no change
no change
no change
no change
no change
no change