Output Bin - Toshiba e-STUDIO 2330c Printing Manual

4 PRINTING FROM UNIX
Option Value Alternate Value
staple=9
If this option is not specified, the printer's default value will be used.
Example: The command to staple in the upper left corner of a long edge feed portrait page is "lp -o staple=1 filename".
The value for the stapling position depends on the paper size, the paper feed direction, and the print direction. This
function is not available for all paper sizes and the users should refer to the copier manual for a list of compatible paper
sizes. In particular, A5, A6 and statement paper sizes will not work with this function.
Select [Tray 2] for stapling with the Finisher MJ-1101 (optional).

Output Bin

The output bin can be specified using the following options.
Option Value Alternate Value
inner
bin1
bin2
If the finisher (optional) is not installed on the equipment, the default output tray will be used (inner). If the finisher option
is installed on the equipment, the default output tray will be used (bin2).
Example: The command to specify output bin 1 is "lp -o bin1 filename".
Hole Punching
When the hole punch option is installed it can be activated using the following option.
Option Value Alternate Value
punch=0 nopunch
punch=1
punch=2
punch=3
punch=4
If this option is not specified, the default value of "nopunch" will be used.
This function is not available for all paper sizes and the users should refer to the copier manual for a list of compatible
paper sizes. In particular, A5, A6 and statement paper sizes will not work with this function.
Example: The command to hole punch the long edge feed portrait page is
"lp -o punch=1 filename".
126 Printing from an Application
Description
Put 2 staples in the middle of a landscape page and fold
the paper in half vertically along the staple line (saddle
stitching). This command works in conjunction with
booklet printing. This command has no affect when the
paper is fed from the long-edge side.
Description
Select the inner tray.
Select the upper output tray of the Finisher (optional).
Select the lower output tray of the Finisher (optional).
Description
Hole punching is turned off.
Hole punch on long edge without rotation.
Hole punch on short edge without rotation.
Hole punch on long edge with 180 degree rotation.
Hole punch on short edge with 180 degree rotation.