Epson 1010 User Manual page 112

10 WIDTH "LPT1:",255
20 LPRINT CHR$(27)"*"CHR$(39)CHR$(42)CHR$(0);
30 FOR X=1 TO 126
40 READ IN
50 LPRINT CHR$(N);
60 NEXT X
70 LPRINT
60 DATA 0,0,63,0,0,127,0,0,255,0,3,255,0,15,255,0,31,255
90 DATA 0,127,255,0,255,255,1,255,255,3,255,255,7,255,255,15),
255,255
100 DATA 31,255,254,31,255,252,31,255,240,31,255,
224,31,255,192
110 DATA 31,255,0,31,252,0,31,240,0,31,224,0,31,120,0,31,240,0
120 DATA 31,255,192,28,255,224,28,127,240,28,15,248,30,0,252,
31,0,126
130 DATA 15,128,15,7,192,7,3,240,7,1,254,7,0,255,7,0,127,135
140 DATA 0,31,199,0,7,231,0,1,247,0,0,255,0,0,127,0,0,63
In this program, line 20 assigns the graphics option (24-pin triple-
density) with code 39. Code 42 sets the number of pin columns at 42.
Lines 80 through 140 contain 126 bytes of data (42-pin columns x 3
bytes) for each pin column. Lines 30 through 60 print the design that
you see below.
Notice that the dots overlap quite a bit. This design was printed
using the triple-density, 24-pin graphics option because the density
is the same (180 dots per inch) in both directions.
Adding the following lines to the preceding program causes the
pattern to print 10 times in a row as shown below.
15 FOR C=1 TO 10; RESTORE
65 NEXT C
4-16
Software and Graphics