Starting Ms-Dos; Exiting Ms-Dos; Changing The Current Drive - Epson Equity LT-286 User Manual

Using an AUTOEXEC.BAT file
l
Starting an application program
l
Using the LIGHTON utility.
l

Starting MS-DOS

Before you can run an MS-DOS application program, MS-DOS
must be running in memory. If you have prepared your hard disk
according to the procedures described in Chapter 3, MS-DOS is
loaded automatically from your hard disk whenever you turn on
your computer (provided you do not have a diskette in the diskette
drive).
When the date and time prompts appear, press
date and time shown. The screen then displays the MS-DOS
command prompt,

Exiting MS-DOS

Before you turn off the computer, make sure the MS-DOS
command prompt (either
remove your diskettes, turn off any peripherals, and then turn off
the computer.

Changing the Current Drive

MS-DOS identifies your hard disk as drive C. Your 3 1/2-inch
diskette drive is identified as drive A. If you have an external
5 1/4-inch diskette drive, that drive is recognized as drive B.
Note
If you wish, you may reverse the drive identifiers for the internal
3 1/2-inch and the external 5 1/4-inch diskette drives by setting
DIP switch 2 on the back panel in the on position. See "Setting
the DIP Switches," in Chapter 1.
5-2
Using MS-DOS With Your Equity LT-286
C>.
or
C> A>)
Enter
appears on the screen. Then
to accept the