Post-Installation Procedures - Epson Endeavor WG User Manual

3. Replace the three cover retaining screws, as shown below.
4. Reconnect the computer to the monitor, printer, keyboard,
and any other peripheral devices you have. Then reconnect
the power cable to the back of the computer and to an
electrical outlet.

Post-installation Procedures

After you install or remove options such as memory modules,
a new processor, or an option card, you must run SETUP to
update the computer's configuration. See Chapter 2 of the
Setup Guide
Additionally, you may need to add some commands to your
configuration files. See your operating system manual and the
manual that came with your optional equipment for
instructions.
You may also want to test a newly-installed option. Some
options come with their own diagnostic programs, and you can
use the diagnostic program on your Reference diskette to test
the system memory, serial and parallel ports, disk drives,
monitor, and display adapter. See Chapter 4 for instructions.
for instructions.
Installing and Removing Options
2-25