Table of Contents
Advertisement
Always turn off the power, disconnect the computer's
power cord, and wait 30 seconds before you remove the
cover. Only remove the cover to access internal devices.
Now you can run the Change Country Code utility.
Running the Change Country Code Utility
Before you configure your computer or perform any other
operations, you need to create new AUTOEXEC.BAT and
CONFIG.SYS files for your country on the Reference 1 diskette.
You do this by running the Change Country Code utility.
This utility creates files that contain the appropriate keyboard
driver and configuration information for the country you select.
The program runs automatically the first time you boot your
computer from the Reference 1 diskette.
Country codes are available for the following countries:
The default country code is United States. See the instructions
in the next section to set the appropriate country code and
create the correct AUTOEXEC.BAT and CONFIG.SYS files.
Later, if you need to change the country code and create new
files, see the "Changing the Country Code" section.
Setting Up Your System
1 - 7
Advertisement
Table of Contents
