Star Micronics LC-20 User Manual page 102

If the paperpark facilitydoesnot appearto be workingcorrectly,checkthe
following:
Check
Possible remedy
Is the paper r elease lever in
Thepaper release lever must be
set to the ~ position
the ~ position?
after the fanfold paper has been parked.
Has the fanfold paper been
Make sure that the indicator comes on flashing
properly parked?
after the fanfold paper has been parked.
If
t e
is beingprinted all on one line, or with extra blanklines, check the
following:
Check
Is the text all on the same
be?
Is text being printed with
extra blank lines?
Possible remedy
Carriage returns are not being expanded to
<CR> + <LF>pairs. Check the DIPswitchsetting and
correct.
Two line feeds are being printed. Make your software
print just acarriageretumor (if this isnotpossible), set
the AUTO LF to OFF with the DIP switch setting.
If thepagelengthandmarginsarenotwhatis expected,checkthefollowing:
I Check I Possible remedv
Isthe printing starting too Use the M icro F eed function to adjust the p rint position
high o r too low onthe p age? relative to the p age.
Does the printer's page
length notmatchthephysical
page length?
Use the DIP switch to setup the correct page length, or
use software commands to do it.
94