Network Install: Software; Install The Drivers; The Ip Address - Oki C5300n Install Manual

Network Install: Software

TCP/IP
Note:
Installing a printer on a network is best handled by
someone familiar with networks (such as a network
Administrator).
For more detailed information on the OkiLAN
8100, see the OkiLAN 8100 SoftNIC User's Guide
on the Publications CD supplied with your printer.

Install the Drivers

The IP Address

An IP address is required to install the drivers. If you are
using DHCP, the IP address will automatically be detected.
If you are not using DHCP, you need to obtain the IP
Address from your network Administrator and enter it using
the front panel:
+
•
Press until you see NETWORK MENU
press .
ENTER
+
•
Press until you see IP ADDRESS SET
+
•
Press to change the setting to
, then .
ENTER BACK
+
•
Press ( IP ADDRESS APPEARS)
+ –
•
Use the and to set each set of digits in the IP Address,
pressing to go to the next set of digits.
ENTER
•
Press , then press
BACK
To Install the PCL Driver
□
Insert the Drivers CD supplied with your printer into the
CD-ROM drive.
The License Agreement appears
□
Click Next.
The Menu Installer window appears.
□
Click the Printer Driver Installer button.
The Local or network printer screen appears.
□
Select Network Printer. Click Next.
The Connection type screen appears.
□
Select Directly to the network ... and click Next.
The TCP/IP Connection screen appears.
on the display, then
, then press
MANUAL , and press
, then press ENTER
.
ON LINE
□
Follow the on-screen instructions to complete the
installation.
To Install the Postscript Emulation
®
Driver
Use the Add Printer wizard:
□
Insert the Drivers CD supplied with your printer in your
CD-ROM drive.
□
Click Next, then click Cancel.
Click Start → Settings → Printers → Add Printer.
□
The Add Printer Wizard appears.
□
Follow the on-screen instructions.
Note:
When prompted to select a port, select LPT1
temporarily.
The Postscript emulation driver is located
under \drivers\network\2000_xp\ps.
.
ENTER
□
Click Finish.
Install the Oki LPR Utility:
Note:
If you have installed the PCL driver using
.
the steps above, skip the next three steps and
launch the Oki LPR utility (
Programs
Oki LPR Utility
□
Relaunch the Drivers CD. When the Menu Installer
screen appears, click Network Software.
□
Click Installation/Config., then click Oki LPR and
wait for the utility to install.
□
When the installation is complete, click Finish to
launch the Oki LPR utility.
Use the Oki LPR Utility to discover the printer:
□
Click Remote Print, then click Add Printer.
□
Select your printer model from the list, then either enter
the IP Address manually, or click Discover and wait
for the printer to be discovered.
□
Click OK.
3
→
Start
→ →
Okidata Oki LPR Utility
).
→