Sears Craftsman 113.213850 Owner's Manual page 8

assembly
i i _ii_ !i_iii_i_ _ _i:i i
2. Remove protective covering from table and
discard. Place table in support and tighten
table lock (located under table) by hand.
I I5
TABLE
SUPPORT "J1
,J
INSTALLING THE HEAD
CAUTION: THE HEAD ASSEMBLY WEIGHS
ABOUT 60 POUNDS. CAREFULLY LiFT HEAD.
1, Remove protective bag from head assembly
and discard. Carefully lift head above column
tube and slide it onto column into position,
Align head with table and base.
HEAD
2. Locate two (2) 318-16x112 set screws among
loose parts bag.
3. Install set screws in right side of head to lock
head into position, and tighten with wrench
provided.
H EAD
LOCKS
HEAD
000
FLATS _.
-%
INSTALUNG FEED AND TENSION HANDLES _ _
1. Locate three (3) rods and three (3) knobs
among loose parts.
2. Screw a knob on each rod, then screw the
other rod end into the threaded holes in the
hub and tighten. Use an adjustable wrench
on the flats provided to tighten the feed rods
securely.
/
/
/
FEED
,_ ROD
FEED
KNOB
HUB