Sears Craftsman 113.213850 Owner's Manual page 11

5. Apply tension to belt by turning Belt Tension
Handle counter clockwise until belt has mod-
erate tension on pulleys.
6. Tighten Belt Tension Lock Handles. Belt
should deflect approximately 1/2 inch by
thumb pressure at center of belt.
7. Close belt guard.
8. If belt slips while drilling, readjust belt
tension.
INSTALLING LIGHT BULB
1. Install a Hght bulb (not larger than 60 watt)
into the socket inside the head.
%
\
ADJUSTING THE TABLE SQUARE TO HEAD
NOTE: The combination square must be "true".
See "Unpacking and Checking Contents" section
for method.
t. insert a precision ground steel rod approxi-
mately 3" long into chuck and tighten.
2. With table raised to working height and lock-
ed on column, place combination square flat
on table beside rod.
,
,
,
6.
If an adjustment is necessary, loosen the set
screw under bevel lock with set screw
wrench, then loosen the table bevel lock with
adjustable wrench. [These adjustments are
located under the table].
Align the table square to the rod by tilting
arm until square and rod are in line.
Retighten table bevel lock nut.
Retighten set screw.
11
ARM
TABLE I/_I _ BEVEL
I I k""C_ I LOCK
o t