Sears Craftsman 113.213850 Owner's Manual page 13

This Drill Press has 12 speeds as listed
below:
300RPM 1450RPM
375RPM 1530RPM
525RPM 2000RPM
560RPM 2200RPM
700RPM 3400RPM
860RPM 4600RPM
Seeright side of Headfor specificplacement
of beltson pulleys.
®
SPINDLE SPEEDS iN R.P.M. ¢_
3OO
,,,._, 700
o ,
2000
¢
375
860
2200
525 560
1450 1530
3400 4600
1. BELT GUARD ...Covers pulleys and belt
during operation of drill press.
2. BELT TENSION HANDLEoo.Turn handle
counter c_ockwise to apply tension to belt,
turn handle clockwise to release belt tension.
3. BELT TENSION LOCK HANDLES... Tighten-
ing handles locks motor bracket support and
BELT TENSION HANDLE to maintain correct
belt distance and tension.
4. HEAD LOCKS.., Lock the head to the col-
umn. ALWAYS have them locked in place
while operating the drill press.
5. COLUMN COLLAR... Holds the rack to the
column. Rack remains movable in collar to
permit table support movements.
6. RACK... Combines with gear mechanism to
provide easy elevation of table by hand oper-
ated table crank.
7. SUPPORT LOCK...Tightening locks table
support to column. Always have it locked in
place white operating the Drill Press.
8. TABLE CRANK... Turn clockwise to elevate
table. Support lock must be released before
operating crank.
9. TABLE SUPPORT... Rides on column to
support arm and table.
10. BASE .o.Supports Drill Press. For additional
stability, holes are provided in base to bolt
Drill Press to floor. (See "Additional Safety
Instructions for Drill Presses").
11. COLUMN SUPPORT,..Supports column,
guides rack, and provides mounting holes for
column to base.
12. COLUMN ... Connects head, table, and base
on a one-piece tube for easy alignment and
movement.
13. BEVEL SCALE ... Shows degree table is tilt-
ed for bevel operations. Scale is mounted on
side of arm.
14.
15.
16.
17.
18.
19.
20.
ARM ...Extends beyond table support for
mounting and aligning the table.
TABLE BEVEL LOCK... Locks the table i_
any position from 0°-45 °.
TABLE LOCK... Table can be rotated in var'_-
ous positions and locked.
TABLE... Provides working surface to sup-
port workpiece.
FEED HANDLE... For moving the quill up o_
down. One or two may be removed if neces-
sary whenever the workpiece is of suoh
unusual shape that it interferes with the
handles.
CHUCK.,, Holds drill bit or other recor'n-
mended accessory to perform desired opera-
tions,
CHUCK LOCKING COLLAR... Draws the
chuck onto the spindle nose. It prevents the
chuck from coming loose during operatiorl.
ALWAYS have the collar tightened.
21. FEED STOP ROD... Holds stop nuts for dri t l*
ing to specific depths.
22. STOP NUTS... Limits the downward move-
ment of the quill at any desired point with _ n
its travel, and prevents the pointer from mov-
ing upward.
23. DEPTH POINTER.,. Indicates drilling depth
and is located between stop nuts.
24. DEPTH SCALE,,. Shows depth of hole beir_ _
drilled,
25. SPRING CAP.,, Provides means to adju,_t
quill spring tension.
26, LIGHT "ON.OFF" SWITCH...Separate
switch to operate light independent of dr_it
switch. This permits the light to be "or_,,
while making setups,
13