Tasks That Can Be Done Using Emp Monitor - Epson EMP Monitor V4.21 Operation Manual

Tasks that can be done using EMP Monitor

EMP Monitor lets you carry out operations such as checking the statuses of
multiple EPSON projectors that are connected to a network at a computer
monitor, and controlling the projectors from the computer.
Following are brief descriptions of the monitoring and control functions that
can be carried out using EMP Monitor.
•
Registering projectors for monitoring and control
- Projectors on the network can be searched for automatically, and you can
then select projectors to be registered from the projectors that are detected.
- You can enter the IP addresses for target projectors to register them.
•
Registered projectors can also be assigned to groups so that they
can be monitored and controlled in groups
•
Monitoring the statuses of registered projectors
- The power status (ON/OFF) for projectors and problems or warnings
requiring attention can be checked visually by means of icons.
- You can select groups of projectors or a single projector that you are
interested in, and then check the cumulative lamp operating time or the
details of information such as input sources, problems, and warnings for
these projectors.
•
Controlling registered projectors
- Projectors can be selected in groups or as single projectors, and you can
then carry out operations for the selected projectors such as turning the
power on and off and switching their input sources.
- Web control functions can be used to change the settings in the projector's
configuration menu.
- If there are certain control actions which are carried out regularly at
particular times or on particular days, you can use "Timer Settings" to
register timer settings.
•
E-mail notification function settings
You can set e-mail addresses to which notifications are sent if a status
requiring attention, such as a problem, occurs with a projector that has been
registered.
Group A
Projector A
Group B
Projector B
System configuration example
TIP
To enable projectors to be monitored and controlled even when they
are in standby mode*, make the following settings at the projectors.
The settings that need to be made will vary depending on the projector
you are using.
s "Configuration menus" in the projector's User's Guide.
•
Set "Network Monitoring" to "ON".
•
Set "Standby Mode" to "Network ON".
* When the projector's (Power) indicator is lit orange
4
I want to turn on the
power for Group A
projectors.
EMP Monitor