Epson Professional Series II User Manual page 23

To maximize the brightness of all the monitors you connect,
always set the
except the last one and set the last monitor's switch to 75R.
For example, if you connect three monitors to one video
controller, set the switches on the monitors as shown below.
If one of the monitors you are connecting does not have a
it only as the last monitor (monitor 3 below).
c o m p u t e r
9. Plug each monitor's power cord into the AC power inlet on
its back panel and then into a grounded (earthed) electrical
outlet.
Connecting three monitors
To connect three monitors to one video interface, follow the
appropriate steps above as well as these general guidelines:
Connect T connectors to the BNC connectors on the first
and second monitors.
Connect the color-coded video interface cable to the
computer's video interface and the appropriate
T connectors on the first monitor.
Use 75Q video interface cables to connect the first monitor
to the second monitor and the second monitor to the third
monitor.
Set the monitors'
of this page.
switches to
switch, it is probably permanently set to 7512; use
monitor 1
HIGH
on all the monitors
monitor 2
switches as described at
Professional Series II Monitor
monitor 3
the
top
15