Advertisement
MOUNTING COVER ASSEMBLYTO
TRACTOR (See Fig. 4)
Use Hardware
- - GROUP
"C"
NOTE:
For ease of assembly, you may wish to obtain the
assistance of another person for mounting assembly to
tractor.
1.
Raise
seat on tractor to allow assembly
to be
mounted.
2.
With cover closed, lift assembly and place support
post inside mounting bracket. Allow assembly to rest
on lanced tabs of mounting bracket,
3.
Line up holes in mounting bracket with holes in support
post and insert bracket support pin. Secure with retainer
spring.
4.
Unlatch and open cover.
5.
Install the three (3) tubing end caps onto container
support.
6.
Tap each end cap onto container support tubes to seat
securely.
BRACKET
COVER ASSEMBLY
SUPPORTPIN
\
I
RETAINER
SPRING
i
END CAP
LANCEDTABS
MOUNTING
BRACKET
FIG. 4
CONTAINER
ASSEMBLY
(See Fig. 5)
No hardware
required
1.
Place bottom haft inside of top half, as shown.
2.
Place one foot inside bottom half and lift top half to
meet bottom half.
3.
Press halves tightly together while lifting top to lock
into place as shown.
IMPORTANT:BEFORELOCKINGTHETABS, HOOKED EDGES
ON BOTHHALVESMUSTOVERLAPTOFORMSEALASSHOWN
IN INSET.
4.
Repeat for other containers.
CONTAINER
BOI-rOM HALF
CONTAINER
TOP HALF
PRESS TOGETHER
TO FORM SEAL
CONTAINER
WHILE UFTING
TOP HALF
TOP HALF
CONTAINER
BOTTOM
HALF
LOCKING
TAB
FIG. 5
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
Page 8
Advertisement
