Advertisement
REAR
MOUNTING
BRACKET
(See
Figs.
1A, 1B & 1C)
NOTE: If your tractor already has four (4) shoulder bolts
installed on the rear drawbar, simply hang the mounting
bracket, lanced tabs towards bottom, on the bolts. Discard
hardware group "A" and disregard the remaining Step 1
instructions.
SHOULDER
BOLTS
LANCEDTABS
TOWARD
BoTroM
FIG. 1A
If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.
Use
Hardware
-
- GROUP
"A"
Only one set of hardware in GROUP "A" will be used to
mount the rear mounting bracket. To determine which set
is correct for your tractor, check to see if there are (2) two
upper corner ribs on each side of drawbar. If your tractor
has the upper corner ribs, use the (4) four self tapping
shoulder bolts. If your tractor does not have the corner ribs,
use the set of (4) four bolts and Iocknuts.
SELF TAPPING SHOULDER
BOLTS (See Fig. 1B)
1.
Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
2.
Hang the mounting bracket, lanced tabs towardsbottom,
on the bolts.
UPPER CORNER
RIBS
SELF
TAPPING
SHOULDER
BOLTS
_
UPPER CORNER
RIBS
!
LANCED TABS
TOWARD BOTTOM
FIG. 1B
BOLTS AND LOCKNUTS (See Fig. lC)
1.
Assemble the mounting bracket, lanced tabs towards
bottom, using the four smaller inside holes on the
drawbar.
2.
Install the four bolts and Iocknuts as shown and tighten
Securely.
LOCKNUTS
BOLTS
LANCI iD TABS
TOWARD RO'I'rOM
FIG. lC
COVER
SEAL
(See Fig. 2)
No hardware
required
1.
Align mark on seal with mark at cover opening,
2.
Work seal into opening so cover sits between flanges
of seal,
AUGNMENT
MARKS
COVERSEAL
FIG. 2
SUPPORT
POST (See Fig. 3)
Use Hardware
- - GROUP "B"
CAUTION: Container support is spring
loaded and locked to the cover. Handle
cover assembly carefully so as not to
unlatch the cover from the container
support.
1.
Rotate cover assembly onto its side as shown.
2.
Assemble support post to container support with
the three (3) carriage bolts and Iocknuts. Tighten
securely.
CARRIAGE
BOLTS
SUPPORT
PO_
7
Advertisement
