Standard Maintenance - Craftsman ETT3012H Owner's Manual

_WARNING: The nailer' must be
turned off and disconnected from the
electrical power source during
maintenance,,
STANDARD MAINTENANCE
, Inspect all screws and tighten if
necessary°
• Use a clean cloth to remove dirt from
tile tool,
, Do not use gasoline, brake fluid, oils, or
solvents to clean plastic parts, These
chemicals will damage, weaken, or
destroy plastics.
• Do not oil or grease any parts°
• Keep the nail magazine chamber clean,
, Do not rotate or remove housing cap,
,_k WARNING: Do not alter or redesign
parts on this nailer, or attach special
fixturing_ This can be a source of personal
injury..
CLEARING A JAMMED BRAD NAIL
1, Turn off power, unplug the cord and
remove all brad nails from the
magazine.
2o Remove the two hex screws and
washers (t) located on the tacking
mouth cover_
3_ Remove the cover (2).
PROBLEM
CAUTION: The safety lock pin (3) and
spring may shoot forward,,
4. Remove the slot cover (4)
5. Remove the jammed brad nailo
6.. Replace all parts in reverse order..
7. Tighten screws°
8, Make sure the safety lock pin (3) is
correctly showing out of the tacking
mouth assembly (5).
J
Nailer will not fire
Brad nail jammed
Turn power on
Plug in
Reset circuit breaker
or fuse
I. Power switch off
2. Not plugged in
3. Circuit breaker tripped
4o Damaged cord
1. Dirty, rusty, or deformed
nails
2.. Incorrect nails
Damaged coil spring
Have replaced by
Sears service center
Replace with new nails
Use recommended
nail style and size
Power loss Have repaired by
Sears service center
7