Maintenance; Troubleshooting - Craftsman 315.FS2000 Operator's Manual

WARNING:
When servicing, use only identical re-
placement parts. Use of any other parts could create
a hazard or cause product damage.
WARNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
To avoid serious personal injury, always
remove the battery pack from the product when
cleaning or performing any maintenance.
pRoBlEM
Work-contacting element does not
depress fully - tool does not operate.
Tool operates properly, but nails do
not drive fully
Tool operates properly, but nails are
driven too deep
Tool jams frequently
Tool stops and LEDs flash rapidly
Tool has charged battery and LEDs
are slowly flashing or LEDs do not
turn off after approximately ten sec-
onds of non-use.

MAINtENANcE

GENERAl MAINtENANcE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.

tRouBlESHootING

poSSIBlE cAuSE
Low nails
Work-contacting element is jammed
Air pressure is too low
Depth of drive isn't deep enough
Nail is too long for wood hardness
Air pressure is too high
Depth of drive is too deep
Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Battery is low or has no charge
Tool is hot
Tool has malfunctioned
12 – English
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc., come in contact with plastic parts. Chemi-
cals can damage, weaken or destroy plastic which
could result in serious personal injury.
Replenish nails
Remove battery and clear debris
Increase air pressure
Adjust depth of drive
Use nail length that is appropriate for
wood
Decrease air pressure
Adjust depth of drive
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Recharge battery
Allow tool to cool
Take tool to nearest authorized repair
center
SolutIoN