Safety Instructions - Craftsman ETT3012H Owner's Manual

• Keep toot wel! maintained Follow
instructions for lubricating and changing
accessories When applicable, keep tool
sharp and clean Inspect cord frequently
and have damaged parts repaired by a
Sears service center. Keep tool handle
and housing clean, dry and free of
grease and oil Never use strong
solvents or petroleum-based products
to clean tool
• Disconnect tool when not in use, before
servicing and when loading or changing
accessorie&
• Avoid unintentional starting, Never carry
tool with your finger on the switch
• Stay alert Watch what you are doing
and use common sense Do not operate
tool when you are tired or under the
influence of drugs, alcohol, or
medication.
- Check damaged parts Berore using
tool, check that all parts will operate
correctly and will perform as designed.
Any damaged parts should be repaired
or replaced by a Sears service center
or other qualified service facility. Also,
check for misalignment, binding, and
broken parts Check that the switch
works properly and do not use the tool
if the switch does not turn the tool on
and off.
. Replacement parts. When servicing, use
only identical replacement parts ordered
from a Sears service center or other
qualified service facility
• Wear hearing protection during extended
periods of operation.
,& WARNING: Always wear eye
protection. Any Power Tool can throw
foreign objects into the eyes which could
cause permanent eye damage ALWAYS
wear safety Goggles (not glasses) that
comply with ANSI safety standard Z87_ 1..
Everyday glasses have only impact-resistant
lenses., ,they ARE NOT safety glasses.
Safety Goggles are available at Sears.
NOTE: Glasses or goggles not in
compliance with ANSIZ87..1 could seriously
hurt you when they break.
,_k WARNING: Do not aim nailer or shoot
brad nails at a person or animal. Released
brad nails can cause severe injuries.
,, Use only the brad nails indicated in this
manual, Use of accessories that are not
designed for this tool could result in
personal injury andlor damage to the tool,
• Do not touch metal parts of tool during
operation, Hold only plastic handle or
housing,
• Keep tacking speed at one brad nail every
two seconds.
• Nailer should be used only for the
purposes outlined in this manual, It is
designed for use on wood Do not use
on hard surfaces like rock, concrete, etco
personal injury or damage to the tool
could result
• Special caution must be taken when
nailing for possible penetration of nails
through the wood into other objects° Use
correct size nails
• When using this tool in high locations,
ALWAYS make sure there is no one
below that could be injured ALWAYS be
sure you have a firm footing when using
this tool
• Always hold too! firmly
• Never connect tool to a DC power
source..
• Regular' cleaning, inspection and
maintenance is necessary,
• During operation, the nailer may feel
warm to the touch. This is normal.
However, if the nailer starts to feel hot,
discontinue use until the unit cools down.
SAVE THESE SAFETY INSTRUCTIONS
3