Troubleshooting - Craftsman 358.341040 Operator's Manual

TROUBLESHOOTING TABLE
WARNING: Always stop unit and disconnect from tile power source be-
fore performing all of the recommended remedies below except remedies
that require unit to be operating.
TROUBLE CAUSE
Chain does 1. Chain tension incorrect.
not move
when trigger 2. Guide bar rails pinched.
switch is 3. Trigger switch failure.
engaged.
4. Circuit breaker tripped/
fuse failure.
1. Chain tension incorrect.
Chain clat-
ters or cuts
roughly.
Chain stops
during cut.
Oil inade-
quate for bar
and chain
lubrication.
Chain cuts
at an angle.
2. Cutters damaged.
3. Chain worn.
4. Cutters dull, improperly
sharpened, or depth
gauges too high.
5. Sprocket worn.
1. Chain cutter tops not
filed flat.
2. Guide bar burred or
bent; rails uneven.
1. Oil tank empty.
2. Oil outlet clogged.
3. Guide bar oil hole
blocked.
1. Cutters damaged on
one side.
2. Chain dull on one side.
3. Guide bar bent or worn.
REMEDY
1. See "Check Chain Tension" in
Maintenance section.
2. Repair or replace.
3. Contact Sears Service
(see back cover).
4. Reset circuit breaker or replace
fuse.
1. See "Check Chain Tension" in
Maintenance Section.
2. Contact Sears Service
(see back cover).
3. Resharpen or replace chain.
4. See "Chain Sharpening" in
Service and Adjustments section.
5. Contact Sears Service
(see back cover).
1. See "Chain Sharpening" in
Service and Adjustments section.
2. Repair or replace guide bar.
1. Fill oil tank.
2. Contact Sears Service.
(see back cover).
3. Remove bar and clean.
1. See "Chain Sharpening" in
Service and Adjustments section.
2. See "Chain Sharpening" in
Service and Adjustments section.
3. Replace guide bar.
If situations occur which are not covered in this manual, use care and good
judgement. If you need assistance, contact Sears Service or the CUSTOMER
ASSISTANCE HELPLINE at 1-800-235-5878.
15