Advertisement
Available languages
Available languages
Become familiar with these terms
When the tank pressure drops to a
before operating the unit.
certain low level the motor will restart
CFM:
Cubic feet per minute,
automatically.
The low pressure
BCFM:
Standard cubic feet per
at which the motor automatically
minute; a unit of measure of air
restarts is called "cut-in" pressure.
delivery.
Cut-Out
Pressure:
When an air
PSlG:
Pounds per square inch
compressor
is turned on and begins
gauge; a unit of measure of pressure,
to run, air pressure in the air tank
begins to build.
It builds to a certain
Code Certification:
Products that
high pressure before the motor
bear one or more of the following
automatically
shuts off - protecting
marks: UL, CUL, ETL, CETL, have
your air tank from pressure higher
been evaluated by OSHA certified
than its capacity.
The high pressure
independent
safety laboratories and
at which the motor shuts off is called
meet the applicable
Underwriters
"cut-out"
pressure.
Laboratories
Standards for Safety.
Branch Circuit:
Circuit carrying
Cut-In Pressure:
While the motor
electricity from electrical panel to
is off, air tank pressure drops as
outlet.
you continue to use your accessory.
This unit is capable of powering the following Accessories.
The accessories
are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.
Accessories
In Line Filter
Tire Air Chuck
Quick Connector Sets (various
sizes)
Air Pressure Regulators
Oil Fog Lubricators
®
Air Hose: 1/4", 3/8" or 1/2" LD. in
various lengths
Refer to the selection chart located
on the unit to select the tools this unit
is capable of powering.
This air compressor
pump is
capable of running continuously.
However, to prolong the life of your
air compressor,
it is recommended
that a 50%-75%
average duty
cycle be maintained; that is, the air
compressor
pump should not run
more than 30-45 minutes in any given
hour.
9-ENG
A09709
Advertisement
