Advertisement
Available languages
Available languages
5.
Run the compressor for 15
minutes. Make sure the drain
valve is open and there is
minimal air pressure build=up in
tank.
6.
After 15 minutes, close the drain
valve (clockwise). The air receiver
will fill to "cut-out"
pressure and
the motor will stop.
The compressor is now ready for use.
Before
Each Start-Up:
1.
Place On/Auto/Off
lever to "Off".
2.
Pull regulator knob out, turn
counter-clockwise
until it stops.
Push knob in to lock in place.
3.
Attach hose and accessories.
NOTE: The hose or accessory
will require a quick connect plug
if the air outlet is equipped with a
quick connect.
pressure causes a hazardous
risk of
bursting,
Check the manufacturer's
maximum
pressure rating for air
tools and accessories,
The regulator
outlet pressure must never exceed
the maximum
pressure rating,
Bow
to Start:
1.
Turn the On/Auto/Off
lever
to "On/Auto" and allow tank
pressure to build.
Motor will
stop when tank pressure reaches
"cut-out"
pressure.
2.
Pull the regulator knob out
and turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to lock in place.
The compressor
is ready for use.
A09709
14-ENG
Advertisement
