Advertisement
Available languages
Available languages
Cooling
System (not shown):
This
compressor contains an advanced
design cooling system. At the heart of
this cooling system is an engineered
fan. It is perfectly normal for this fan
to blow air through the vent holes
in large amounts. You know that the
cooling system is working when air is
being expelled.
Air Compressor
Pump:
Compresses
air into the air tank. Working air is
not available until the compressor has
raised the air tank pressure above
that required at the air outlet.
Drain Valve: The drain valve is
located at the base of the air tank
and is used to drain condensation
at
the end of each use.
How to Use Your Unit
Bow
to Stop:
1.
Set the On/Auto/Off
lever to
"Off".
Before
Starting
Break=in instructions
Valve
Drain
Valve
Check Valve: When the air
compressor
is operating, the check
valve is "open", allowing compressed
air to enter the air tank.
When the
air compressor
reaches "cut-out"
pressure, the check valve "closes",
a!lowing air pressure to remain inside
the air tank.
Pressure
Release Valve:
The
pressure release valve located on
the side of the pressure switch, is
designed to automatically
release
compressed
air from the compressor
head and the outlet tube when the
air compressor
reaches "cut-out"
pressure or is shut off. The pressure
release valve allows the motor to
restart freely. When the motor stops
running, air will be heard escaping
from this valve for a few seconds.
No air should be heard leaking when
the motor is running, or continuous
leaking after unit reaches "cut-out"
pressure.
damage
may result if the following
break-in
instructions
are not
closemy followed.
This procedure is required before the
air compressor
is put into service and
when the check valve or a complete
compressor
pump has been replaced.
1.
Make sure the On/Auto/Off
lever
is in the "Off" position.
NOTE: If quick connect is installed,
pull coupler back until it clicks to
prevent air from escaping through the
quick connect.
2.
Plug the power cord into the
correct branch circuit receptacle.
(Refer to "Voltage and Circuit
Protection" paragraph in the
"Installation"
section of this
manual.)
3.
Open the drain valve fully
(counter-clockwise)
to permit
air to escape and prevent air
pressure build up in the air tank
during the break-in period.
4.
Move the On/Auto/Off
lever
to "On/Auto" position. The
compressor
will start.
13-ENG
A09709
Advertisement
