Advertisement
Available languages
Available languages
Contents
of Carton
1 - Air Compressor
1 - Parts bag containing:
1 - Owner's Manual
4 - 5/8" Washers
1 - Conduit Connector
Tools
Required
for Assembly
1 - 9/16" socket or open end wrench
1 - Electric drill
Unpacking
1.
Remove all packaging.
lt may be necessary
to brace or support
one side of the outfit when removing
the pallet because the air compressor
will have a tendency to tip.
2.
Remove and discard the (4)
screws and washers holding the
compressor to the pallet.
3.
With the help of another person
carefully remove air compressor
from pallet and place on a level
surface.
_This
compressor
was
__
shipped with oil in
the pump crankcase. Check oil before
operating air compressor, see Check
Oil under Maintenance.
HOW TO SET UP YOUR
UNiT
Location of the Air Compressor
•
Locate the air compressor
in a
clean, dry, and well ventilated
area.
•
Located the air compressor at
least 12" (30.5 cm) away from
the wall or other obstructions
that will interfere with the flow
of air.
•
Locate the air compressor
as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring.
NOTE: Long lengths of electri-
cal wiring could cause power
loss to the motor.
•
The air filter must be kept clear
of obstructions
which could
reduce air flow to the air com-
pressor.
Anchoring
of the Air Compressor
E__
Risk of Bursting.
__
Excessive
Vibration
can weaken
the air tank
and cause an explosion.
The
compressor
must be properly
mounted.
The air compressor MUST be bolted to
a solid, level surface.
Hardware needed:
4 - Concrete anchors
(not supplied)
4 - 3/8" Lag screw to fit concrete
anchors
(not supplied)
4 - 5/8" Washer (supplied)
shims (if needed)
1.
Place the air compressor
on a
solid, level surface.
2.
Mark the surface using the holes
in the air compressor feet as a
template.
3.
Drill holes in the surface for the
concrete anchors. Install concrete
anchors.
4.
Line-up holes in surface with holes
in air compressor feet.
5.
Place the (4) washers (supplied)
between the floor and air com-
pressor feet. If needed, solid
shims may be placed between the
washers and floor to evenly dis-
tribute weight on all four feet. See
next figure.
N004035
10-ENG
Advertisement
