ASSEMBLY
GAUGE WHEEL
MOUN_NG
BRACKET
\
3/8-16
LOCKNUT
_8"WASHER
GAUGE
_SHOULDER
BOLT
FIG. 4
INSTALL MULCHER PLATE
(See Figs. 5 & 6)
Install two latch hooks to mulcher plate using screw,
washer, lock washer, and weld nut as shown.
NOTE: Pre-assemble weld nut to latch hook by inserting
weld nut from the top with hook pointingdown.
•
Tighten hardware securely.
•
Raise and hold deflector shield in uprightposition.
•
Place front of mulcher plate over frontof mower deck
opening and slide intoplace, as shown.
•
Hook front latch intohole on frontof mower deck.
•
Hook rear latch into hole on back of mower deck.
CAUTION: Do not remove discharge
guard from mower. Raise and ho|d
guard when attaching mulcher plate
and allow it to rest on plate while in
operation.
WELD NUT FROM THE TOP
HOOK POINTS DOWN
LOCK
WELD
WASHER
NUT_
SCREW
LATCH
HOOK'--..
HOOK
WASHER
MULCHER
PLATE
LOCK
WASHER
WASHER
'_""_SCREW
WELD
NUT
TO CONVERTTO
BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in a safe place.
Your mower is now ready for dischargingor installationof
optional grass catcher accessory.
DEFLECTOR
HOOKS
FIG. 6
,/CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE
THE BEST PERFORMANCE AND SATISFACTION FROM
THIS QUALITY PRODUCT.
PLEASE REVIEW THE FOLLOWING CHECKLIST:
,/
All assembly instructionshave been completed.
,/
No remaining looseparts in carton.
/
Battery is properlyprepared and charged. (Minimum
1 hour at 6 amps).
•/
Seat is adjusted comfortablyand tightened securely.
,/
Alltires are properly inflated. (For shippingpurposes,
the tires were overinflatedat the factory).
,/
Be sure mower deck is properly leveled side-to-side/
front-to-rear for best cutting results. (Tires must be
properly inflatedfor leveling).
,/
Check mower and drive belts. Be sure theyare routed
properly around pulleys and inside all belt keepers.
,/
Check wiring. See that all connectionsare stillsecure
and wires are properly clamped.
WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY
EXTRA ATTENTION TO THE FOLLOWING IMPORTANT
ITEMS:
•/
Engine oil is at proper level
,/
Fuel tank is filled with fresh, clean, regular unleaded
gasoline.
,/
Become familiar with all controls- their locationand
function. Operate them before you startthe engine.
/
Be sure brake system is in safe operating condition.
FIG. 5
9